##### ORBNET Alarm Server v1.1.10 # Intelbras AMT Remote Setup in Intelbras the Monitoring Transmission to be the Milestone XProtect server with the Event Gateway installed. ![[sc1.png]] The Alarm protocol used should be **Contact ID** ![[sc3.png]] For Settings and Parameters, Note the Server TCP/IP, Remote programmer client connection port. ![[SuccesfullConfiguration.png]] # Event Gateway Open in the **XProtect Management Application** > ORBNET Plugins > Event Gateway Receivers - Add a new **Receiver**. - Enter the relevant **Account Number** - Add your panel **IP Address** - Enter the port used for remote communication, example: **9009** ![[Pasted image 20241220172340.png]] - Set the **Panel Type** to [Intelbras] - Under the **Intelbras** category input **Password for Intelbras Panel** ![[Pasted image 20241220172552.png]] ## Event Gateway License Select Event **Gateway License** - Ensure the **Event Gateway** is running a valis license and does not need validation, like the below example. - Apply a license to the new panel - Use Save next to File - Restart your **XProtect Event Server** ![[Pasted image 20241220172950.png]] Check back in Event GatewayReceivers under the Intelbras panel. Use the **Last 1000 received messages** to check that you are now receiving messages from the panel. Check Windows Firewall Rules to ensure the port is open to incoming communication from the panel. ## Event Gateway Models / Templates Create a Model / Template for each Alarm Point Type, these are used for Alarm Points. - Using **Auto Alarms for alarm Codes** does mean that Alarms are generated without the need of dedicated **Alarm Definitions**. Set to [True] if you wish to use this. Otherwise for more granular control of triggering alarms use **Alarm Definitions**. ![[Pasted image 20241220174318.png]] ## Alarm Points Match you Alarm Panel configuration in Alarm Points ![[Pasted image 20241220174515.png]] # XProtect Alarms **Alarm Definitions** can be created with **Intelbras** event types. - Select **AlarmServer** as the Triggering Event - Select the Intelbras Triggering Event Type - Update to the relevant source/s ![[Pasted image 20241220173326.png]] # XProtect Smart Client Create a Map in a new Tile with a floorplan of the site. Mapping provides alarm points that can be put into location on a site plan, with colour codes to provide point alarm status. Right click the alarm point for additional Intelbras controls. - ARM - DISARM - BYPASS - UNPASS - TOGGLE ![[Pasted image 20241220175113.png]] Add the panel to the site plan, wen you right click and select [status] the point states are shown. ![[Pasted image 20241220175317.png]]